Types of Pipe Fittings

Whether you are looking to install new pipes, or to replace existing ones, there are a number of different types of pipe fittings to choose from. These fittings are used to join, connect, and terminate different parts of a plumbing system. They are shaped like tubes or plugs and are generally made of copper, brass, or plastic. They are usually soldered, but are also available with a threaded end. They are usually used to link pipes of different sizes and shapes. They are typically used in residential, commercial and industrial applications.

Image credit

Tee pipe fittings are commonly used in water supply lines. They are designed with one inlet and two outlets. They have an equal length on all three sides of the fitting. They are arranged at a 90 degree angle to the main pipe. They can be used to redirect a portion of the flow to a side branch connected to a heat exchanger. They are also used in pressurised hydronic heating systems.

There are a variety of elbow fittings, which are mainly used in 45-degree turns. They are shaped like a T, and have male threads on one end and female threads on the other. The most common uses of these fittings include connecting hoses to water pumps, deck drains, and valves. They can be made in any size, angle, or radius, and can be cut to fit any shape. When you need Copper Pipe Connectors, go to watkinspowis.co.uk/products/copper-pipe-fittings-and-press-systems/

Wye fittings are similar to tees, but have a lower frictional loss and smoother angling. They are used to connect vertical drain pipes to horizontal pipes and to branch off into a new line. These fittings are manufactured from plastic, rubber, or steel. They are often secured with a nut or bolt. They are also used in drainage systems and in garden production. They are also used to avoid obstructions in a pipe run.

Image credit

Bushings are also used in plumbing. These fittings are used to make an abrupt change in diameter, and occupy less space than a union. They are commonly made from PVC, copper, or galvanised steel. They can be threaded on both sides, and they are commonly used in dead ends and future connections. They can be applied by using glue, or they can be soldered and are found in a variety of applications used in conjunction with a cap to close the ends of a pipe.

Adapters are also common in piping systems. They are short fittings that are used to join different pipes to fixtures. They may have male IPS (integrated piping system) or female IPS (integrated piping system). They are often welded to the smaller pipe.


Leave a Reply

Your email address will not be published. Required fields are marked *